Kwa mac 11 ns2 maintenance
Select S to fire semi-automatic single shot and select F to fire full automatic continuous fire. The safety button is located in front of the trigger.
Покупайте с уверенностью
Push the wire handles inward. Swing the wire handles downwards until it locks. Press and hold the stock button while pulling the stock slightly outward. Release the stock button. Pull the retractable stock until the stock locks into position. Swing Downward. To remove the retractable stock from the gun, press and hold the stock button and pull the stock out completely.
Choose shooting mode. Disengage the safety. Squeeze the trigger to fire. It is recommended eye protection be wore at all times. BBs may bounce off hard surfaces ricochet. Always point gun in a safe direction.
The bolt will lock halfway and the ejection port will remain opened. It is important to treat your gun as though it is loaded, even if the bolt remains open.
Airsoft Guns, Shop By Rifle Models, UZI / MAC / MAC - agfox.com Airsoft Superstore
Airsoft BBs are light-weight and can be affected by wind when fired. With the Hop-Up system, the trajectory of the Airsoft BBs can be adjusted according to the shooting environment or surroundings. Remove the magazine. Open the slide and place adjusting tool into the slotted chamber ring. If the BBs are dropping too quickly, move the adjusting ring to the left or counter-clockwise to give the BB more hop. If the BBs are dropping too slowly, move the adjusting ring to the right or clock-wise.
Test fire and adjust as needed. Remove the magazine by depressing the magazine catch. Remove the stock from the receiver see pg Pull the bolt handle to lock the bolt. Check and clear the chamber from any BBs. Using your finger tip, or small pen like tool, press down on the retaining pin 1, from within retaining pin 2, and pull it out from opposite end.
Pull retaining pin 2 out from the receiver. The pin is seated tightly in the receiver, considerable effort may be needed to pull it out. Pull the upper frame upward and forward until it stops on bolt handle. Remove the upper frame off of the lower frame. After the upper frame is removed, push the bolt backward and then lift the bolt upward. Make sure the hook underneath the bolt clears the impact block. Place the recoil spring onto the bolt assembly.
Lock the bolt assembly onto the upper frame.
- mac customer support phone number;
- smart notebook math tools download for mac?
- KWA Full Metal 48 Round Magazine for KWA M11 Airsoft Gas Blowback (NS2 System).
Install the upper frame onto the lower frame and align the bolt knob hole. Make sure the hook underneath the bolt hooks onto the impact block 4. Push the bolt knob into the bolt assembly and push the slide assembly to the rear.
Покупки по категориям
Align the retaining pin holes. Insert the 2pc retaining pins. Cycle the bolt to ensure proper assembly before shooting. Bolt Knob. With lubricating silicone oil, it will extend the life of the seals and o-rings and prevent gas leaks.
UZI / MAC-10 / MAC-11
Any other type of lubricant may damage the products. Lightly lubricate the recoil spring, cylinder and moving parts with a few drops of oil.
Lubricating the seals and o-rings are essential. Unload BBs from the magazine. Operating Under Unusual Conditions Unusual conditions are defined as any condition requiring special maintenance. It makes a great secondary for snipers or can be used as a CQB weapon though it won't fit into most holsters. Also with the PolarStar silencer it looks badass.
Format your post better, proper use of bold and lists make it easier to read. I have the same thing, and while this thing is amazingly fun, it does have some issues but i still recommend it The magazines can have some trouble; a part on the inside of one of mine got a little broken, and it bounced around inside the magazine. I had to take it apart and use loctite on it, but it works.
Another, the o ring near the intake valve just disappeared, and seems to fall out easier than in other guns. My gun doesn't catch when it is out of bbs anymore because there was a tiny bit of something on the bb pusher in the magazine. It's a high maintenance gun, but is very very fun. Whenever I test it before a game, people always turn and look or ask if they can try. It has a very loud and menacing sound. Oh yeah, but it is hella cumbersome to carry around. There is a very little chance of getting smaller magazines. They used to be made, but are very rare now.
Did you not read the thing that said "pictures to come"?
KWA M11 GBB SMG NS2 - Black
The only issue being that you have to store it with the mag out. They really are a bit too bulky and un-ergonomic to be a back up weapon. The body of the KWA M11A1 is made out of a reinforced polymer that is both lightweight and extremely durable. Staying true with its real-steel counter part, the KWA M11A1 fires from a true open bolt system - giving the operator a more unique experience when firing the gun. The M11A1 features an vertical folding stock that can be extended for more accurate shots.
Using KWA's revolutionary NS2 gas system, the M11A1 is extremely gas efficient - which is very useful given its high rate of fire of rounds a second. It also provides a very crisp blowback when firing the gun. All Items will ship out next business day. This is a fun gun when it works. I even bought another magazine and still had the same problems.
I think if it were a single stack magazine it would have less rounds but no more jamming