Ifixit mac mini ssd install

Buy these tools.

Buy these parts. Rotate the bottom cover counter-clockwise until the white dot painted on the bottom cover is aligned with the ring inscribed on the outer case. Remove the two Lift the ear of the fan nearest the RAM up off the standoff secured to the outer case. Removing the standoff screw is not necessary to remove the fan. You need only raise the fan enough to lift it off the standoff screw. Grab all the wires at once and gently pull straight up to disconnect the fan from the logic board.

Alternatively, slide a spudger underneath the wires and pry up to disengage the connector. Do not pry at the socket, or you will rip it from the logic board. It can be difficult to get the hard drive seated correctly such that the antenna plate fits in place correctly. If the screw holes don't line up with those on the hard drive, make sure that the two pins that are in the back of the hard drive are properly seated in the holes at the back of the case, above the housing for the second hard drive. The antenna attaches directly to the hard drive red markers , therefore attaching the antenna can move the hard drive around and loosen the connection of the hard drive cable to the logic board.

Do not remove the antenna plate yet. Use the flat end of a spudger to pry the hard drive connector up from its socket on the logic board.

Use the tip of a spudger to lift the IR sensor connector up and out of its socket on the logic board. To remove the logic board, the two cylindrical rods of the Mac mini Logic Board Removal Tool must be inserted into the holes highlighted in red. Inserting instruments into any logic board holes other than the ones highlighted in red may destroy the logic board.

Be sure it makes contact with the top side of outer case below the logic board before proceeding. Pull the hard drive away from the front edge of the mini and remove it from the outer case.

• Mac mini Late Teardown - iFixit.
• 4 Categories.
• Introduction.

During reassembly, there are two pins on the inside edge of the hard drive that fit into the case. The holes have rubber grommets around them, so it may be difficult to tell when you have seated the hard drive correctly. There are two pairs of holes in the case. Insert the pins into the holes closest to the bottom of the case. If you are installing a new hard drive, we have an OS X install guide to get you up and running.

I did not complete this guide.

Introduction

Maybe also include a install guide for This also worked for me. Follow machobbes advice - whole process took about 10 minutes. Easy peasy. Best solution if you are having this problem is to turn the Mini upside down, ensuring that the antenna cable isn't stretched too far, and aided by the wonderful powers of gravity, get the new HDD unit fixed into place properly.

Popular Parts & Tools

Select a Language: Help Translate iFixit. Walter Galan and 11 other contributors. Difficulty Moderate. Steps Time Required 30 minutes - 2 hours. Sections 7. Flags 0. Introduction Use this guide to completely replace your mini's hard drive.

Only problem with taking it apart was with the IR sensor was difficult to lift up and I ended up pulling the whole fitting off glued it back on but now have no working IR sensor or front light but everything else works fine. Select a Language: Help Translate iFixit. Sam Lionheart and 13 other contributors. Difficulty Moderate. Steps Time Required 30 minutes - 2 hours. Sections 8. Flags 1. Featured Guide This guide has been found to be exceptionally cool by the iFixit staff. Introduction Use this guide to replace the hard drive in your hard-drive-only or Fusion Drive Mac mini Late Tools Buy these tools.

Parts Buy these parts. Step 1 Bottom Cover. Add Comment. Step 2.

1. Mac mini Repair - iFixit;
2. modio for mac book pro.
3. Mac mini Mid Hard Drive Replacement - iFixit Repair Guide.
4. how to change mp3 properties mac?
5. Mac mini Late Hard Drive Replacement - iFixit Repair Guide.
6. action movie fx for mac?

One comment. Step 3. Step 4 Antenna Plate. Step 5. Add a comment. Step 6. Step 7.

Mac mini Late 2018 Teardown

Step 8. Step 9. Step 10 Fan Assembly. Step Browse Our Store. Step 14 Logic Board Assembly. Tools used on this step:. Step 26 Power Supply. Step 31 Drive Tray Assembly. Step 33 Hard Drive Assembly. Step 35 Hard Drive. Almost done! To reassemble your device, follow these instructions in reverse order. You're Finished! Author with 13 other contributors.